|
Q:
What is the power spec. of APW-1000?
A: Input: 120V, 60Hz, 18.5W; Output: 12VDC,
1A
Back to top
Q:
Can I use a 24VAC 1AMP supply
with APW-1000, since the unit has a regulator?
A:
The built-in switching power regulator of APW-1000 is a DC regulator, therefore
you must adopt the 24VDC 1AMP power supply as the regulator can only take the
DC power supply. And the input voltage should be between 12VDC and 28VDC as stated
in the installation guide.
Back
to top
Q:
Does the power cable comes
with APW-1000 has bare wire at the end? And does it support a screw down terminal
block?
A:
Yes,
you can use a power supplies with the screw terminal block to connect to the bare
wire side of the power cable that comes with the amplifier.
Back
to top
Q:
Will both 12VDC 500mA and
24VDC 1A with screw terminal block work on APW-1000?
A:
Yes,
both all work fine, but it is indeed 24VDC with 1 amp shall give you the most
benefit of it.
Back
to top
Q:
What kind of patch cable
to use on Trango M5830-AP which has reverse polarity SMA connector?
A:
You
will need a reverse polarity to Trango system, and normal polarity to APW-1000.
Back
to top
Q:
Are
both SMA ports of APW-1000 male and/or female with outside thread?
A:
Both
"RF in" and "RF out" connector located on APW-1000 are female connector, therefore,
you'll need male connector with outside thread to connect to amplifier.
Back
to top
Q:
What is the dBm of APW-1000?
And how do I increase it?
A:
APW-1000
provides roughly +30dBm. Change to high gain antenna will certainly increase the
dBm. For example, if combine APW-1000 with an 18 dBi antenna, you will be able
to get a total 48 dBm.
Back
to top
Q:
Which
RF-Link product that APW-1000 works with?
A:
APW-1000
works with AVS-5808 to extend transmission range. It also works with RF-Link's
5.8GHz wireless RF module as part of our OEM offering.
Back
to top
Q:
Does APW-1000 amplify all
RF bands: VHF, low and high FM and four CATV bands?
A:
No,
it does not.
Back
to top
Q:
Does
APW-1000 compatible with HDTV signal?
A:
No.
it does not.
Back
to top
Q:
Can
I take out the board from APW-1000 and place it in a plastic box instead of the
metal box that come with it? And by doing so, will it affect any of its performance?
A:
It
is all right to place the APW-1000 board inside a plastic box. However, by doing
so, the customer must pay attention to the issue of heat ventilation as APW-1000
will be generating a great deal of heat. And generally speaking, putting APW-1000
board in a plastic box will do very little to affect its performance as long as
the antenna is exposed outside the box. Please note, this action may revoke the
product warranty.
Back
to top
Still
cannot find your answer? Contact
our technical support for further assistance.
| 
